NEED4ENGINEER
ব্লগ
ক্যালকুলেশন
নাম-ঠিকানা
এস্টিমেট
ম্যাটেরিয়াল
অন্যান্য
কুইজ
গ্যালারী
প্রশ্ন
চেকশীট
ম্যাথপ্যাড
লগ-ইন
Search by keyword
Civil Quiz 7
In distribution pipes, air valves are provided at
Lower points
Junction points
Higher points
Anywhere
The velocity ratio for the second system of pulleys is n.
TRUE
FALSE
Both A and B
None of the above
A track of width 1 to 1.2 m constructed along the selected alignment to facilitate access to the area for inspection and detailed survey is known as
inspection trace
terrain
trace out
all of these
The station having two lines is called a
crossing station
flag station
junction station
terminal station
The standard width of ballast for M.G. track in Indian Railways, is kept
3.35 m
3.53 m
2.30 m
2.50 m
Selection of drilling equipments depends on a _______
Availability of water for drilling
depth of holes required
hardness of rock
All of the above
The bricks after burning in kilns require about
4
8
10
12
Which level of management is responsible for establishing a vision for the organization, developing broad plans and strategies, and directing subordinate managers?
first level managers
middle managers
executive managers
second level managers
Which type of environment is best suited for mechanistic organizations?
Dynamic
Manufacturing
Service
Stable
A mix with water-cement ratio of 0.78 is termed as wet mix.
Yes
No
Both A and B
None of the above
The expected out turn of half brick partition wall per mason per day is
1.5 m3
2.0 m3
4.0 m2
5.0 m2
Terzaghi's bearing capacity equation is not applicable for
depth effect and inclination factor
narrow slope
none of the mentioned
all of the mentioned
Hydration of cement evolves heat.
TRUE
FALSE
Both A and B
None of the above
The diagram shown below, depicts bending diagram for
cantilever beam with uniformly distributed load
cantilever beam with uniformly distributed load only on half side of the beam
simply supported beam with varying distributed load
simply supported beam with uniformly distributed load
The ratio of the difference between the void ratio in its loosest state and its natural void ratio to the difference between the voids ratio is the loosest and the densest state, is called
density index
relative density
degree of density
any one of these
In addition to place , labour and money which other internal environment factor influences management?
Organising
Management
Control
Machines
Super-fluous water is also called
capillary water
gravitational water
hygroscopic water
all of these
In an inward flow reaction turbine the discharge
Increases
Decreases
Same
Independent
The natural outflow of sub-surface water at the surface is termed as spring.
Correct
Incorrect
Both A and B
None of the above
Which of the following is not a suggestion for motivating employees?
Recognize individual differences
Makes goals very difficult to achieve
Match people to jobs
Individualize rewards
The curve for Nq and N? for the transition state from ? = 28_____ and ? = 38_____ was given by
peck
hanson
thorn burn
all of the mentioned
A pentagon is placed parallel to horizontal plane which of the following projection is true?
front view-line, top view- pentagon
front view- pentagon, top view- line
front view –line, top view-line
top view- line, side view- line
Though the effective depth of a T-beam is the distance between the top compression edge to the centre of the tensile reinforcement, for heavy loads, it is taken as
1/8th of the span
1/10th of thespan
1/12th of thespan
1/16th of thespan
Rise of water table above the ground surface causes
Equal increase in pore water pressure and total stress
Equal decrease in pore water pressure and total stress
Increase in pore water pressure but decrease in total stress
Decrease in pore water pressure but increase in total
Which of the following is a function of how much decision-making authority is pushed down to lower levels in the organization?
Departmentalization
Centralization
Span of control
Power
Which of the following is not a transition curve?
Compound curve
cubic spiral
Cubic parabola
True spiral
Primary treatment of sewage consists of removal of
large suspended organic solids
oil and grease
sandand grit
floating materials
For general engineering purposes, soils are classified by
Particle size classification system
Textural classification system
High Way Research Board (HRB), classification system
Unified soil classification system
The momentum correction factor ? is used to account for:
Change in direction of flow
Change in total energy
Non-uniform distribution of velocities at inlet and outlet sections
Change in mass rate of flow.
Slate is used for
building walls
road metal
manufacture of cement
roofing
Entry into the profession requires an extensive period of training of intellectual and moral character
knowledge and skills
extensive training
monopoly
autonomy
need4engineer.com
, All rights reserved.
Designed By
HTML Codex